We often get asked to do bathroom refresh and end of tenancy tile cleans however it’s a good job I’m not squeamish as this ceramic tiled shower cubicle was in a bad way.
The property was in the historic village of Herstmonceux in the Wealden District of East Sussex and apparently it had been leased to students who it seems were averse to cleaning, no surprise there.
Cleaning Ceramic Tiled Shower Cubicle
The first step was to remove the plastic product holder to expose the tile and grout, which revealed more staining and black mould.
With that removed I sprayed the Tile and Grout with Tile Doctor Oxy-Gel which works better than liquid products as being gel based it sticks to the wall tile and grout and really gets to work breaking down the dirt. I left this for a few minutes before scrubbing it and then rinsing it off with water. I had a problem with a patch of grout which was beyond cleaning and concerned it was going to upset the whole job I raked out it and applied new grout.
Grout Colouring Shower Wall Tiles
With the tiles now clean and fresh grout dried the next step was to apply a White Grout Colourant to ensure all the grout had a consistent appearance. Although time consuming the grout colourant is easily applied with a small brush and then you wipe off any excess that gets onto the tile.
The next step was to strip out the mastic silicone sealant strip from around the base of the shower cubicle and replace with new. I used high quality silicone sealant that left nice lines and fresh look, don’t use cheap sealant as it will soon discolour and some have been known to shrink.
Last step was to replace the plastic product holder which had been cleaned.
Quite a difference I think you’ll agree. Future cleaning advice was left with the customer; I just hope he passes it onto the next tenant.
Stained Ceramic Tiled Shower Cubicle Refreshed in East Sussex
As you can see from the photographs below the ceramic tiles and grout in this Shower Cubicle in East Sussex were in need of a deep clean. Ceramic tiles are very easy to clean however the grout was very discoloured and so we decided to apply a grout colourant.
Cleaning Shower Tile and Grout
To clean up the ceramic tiles and grout we sprayed on Tile Doctor Oxy-Pro which is a specialist Shower Tile and Grout Cleaner, the spray allows the cleaning agent to mix with air making it lighter and easier to stick to vertical surfaces. This is important as you need to let the cleaning agent dwell on the surface of the tile and grout for a few minutes before scrubbing it by hand with a stiff brush and then washing it off with clean water.
The cleaning process managed to clean up the tiles and did make a difference on the grout but there was quite a few stains left on the grout so we proceeded with grout colouring starting with the application of the Pre-Treater which prepares the grout ensuring a good bond with the grout colouring product.
Once the Pre-Treater had dried I started the application of the white grout colourant which you work into the grout using a toothbrush, for best results you need to work it forwards and backwards to achieve an even coat. I used two coats of grout colourant in the end to ensure shadowing from some of the darker stains were not visible.
These grout colouring products are self sealing so after 24 hours it is fully cured and protected. Last step was to strip out the old silicone at the bottom of the shower, this had gone a bit mouldy and once mould gets a hold on silicone it’s impossible to get rid off, we replaced the sealant with a fresh White Mapeisil waterproof silicone.
The renovation was now complete, tiles cleaned, grout restored and sealant replaced; naturally the customer was very pleased with the results as the shower looked like new again.
Shower Cubicle Restored in East Sussex